It would be great if every catechetical classroom could have multiple icons for use in prayer built to withstand regular use by small hands. Unfortunately, mounted icons can be quite pricey and outside the budget of many parishes. However there is an easy DIY solution that produces surprisingly beautiful results.
For this project you’ll need
- a computer and printer
- Mod Podge craft glue (I find the glossy variety works best)
- a sponge brush
- a backing board (I cut down some scrap plywood, but you could use pre-sized canvas panels or even some study cardboard)
First, find the image you want to mount and print it out. I find a lot of public domain religious images on Wikipedia Commons; just search for a saint or Bible story. Cut the printed image out, leaving a slight border.
Next, cut your backing to size — you’ll want it a little smaller than the printed image.
Next, apply the Mod Podge to your backing. Don’t worry about using too much — it’s fine if it soaks through the paper.
Glue the image to the backing, then cut out some notches at the corners (see above). This will create four “flaps.”
Apply glue to the “flaps” and fold them over onto the backing.
Let the glue dry for 15-20 minutes, then apply some Mod Podge to the front of the image. This will give it a glossy protective coating.
Let the finished project dry for 1-2 hours and you’re done! I was able to produce three of these in about 30 minutes; cutting the plywood was the hardest part!
This is a simple project that can help catechists evangelize with beauty. It could also be adapted as an activity for families as part of an inter-generational catechetical event!